You can define which output pages will be generated.

Depending on the type of installation, f.ex. NFPA (the overview is generated according to VdS specifications / FM specifications by default)

Perhaps the pipe lengths and pipe lists are also of interest for an initial material overview.



Pipe list

This list includes all pipes, branch pipes and sprinkler feeds. Pipes of the same diameter and length are grouped together. 

The table contains the following columns

  • DN value : pipe diameter,
  • Length : Pipe length,
  • Identification : Pipe type, number and sub-number,
  • Start node : Start node of the pipe,
  • End node : End node of the pipe.
  • For each entry in the table the column Identification contains a list of all pipes of this diameter and length. Start and end nodes correspond to those in the result files of the calculation program.


The following example contains the pipes of a sprinkler system with nodes and identifier of IDAT program:


Fittings list

This is a list of elbows, tees, gate valves, flaps and alarm valves. 

Identical fittings are combined.


The table contains the following columns:

  • Number : Number of identical fittings,
  • Type : elbow/angle/t-piece/gate valve/flap/valve,
  • 1. diameter : 1. diameter (only for elbows, angles and tees),
  • 2. diameter : 2. diameter (only for bends, angles and tees),
  • 3. diameter : diameter at the centrepiece (T-pieces only).


The following example printout contains the summary of the fittings:


Pipe length

A summary of the pipe lengths used as a material summary.